DE IT EN

Mountain biker on a narrow trail beneath the rock faces of the Dolomites

The singletrail scale: S0 to S5

The Singletrail Scale (STS) helps you assess the technical demands of a trail. Here are its six grades, from S0 to S5.

HOW TO READ THE SCALE

Assess the skills. Know your limits.

The STS rates flat and descending trails by their features, assuming dry ground and sufficient daylight. Its reference is an average rider on a modern MTB. The scale is open-ended at the top.

S0 · S1 Easy

S2 Moderate

S3 · S4 · S5 Difficult

Important: Exposure to a fall, weather, light and speed are not included in the S grade. Wet conditions or higher speed can make a section considerably more demanding.

THE SIX GRADES AT A GLANCE

From S0 to S5

S0

Easy

No particular obstacles

Trails generally roll over firm, grippy natural ground or compacted gravel. Rocks, steps and root sections are not characteristic features. The gradient is gentle to moderate and the corners are wide.

Riding skills: No special riding techniques are required.

Gradient: Gentle to moderate · S0 in the original source ↗

S1

Easy

Small obstacles, basic riding skills

Shallow roots, small stones, drainage channels or eroded patches interrupt the trail. The surface may be loose. Corners become tighter, but there are no tight switchbacks yet.

Riding skills: You need basic riding skills and must remain attentive. Obstacles can be rolled over. Ride standing up as a general rule; controlled braking and weight shifts help on more demanding sections.

Gradient: Up to 40% (about 22°) · S1 in the original source ↗

S2

Moderate

Larger obstacles, deliberate control

Larger roots and stones characterise the often loose surface. Shallow ledges, steps, tight corners and straightforward switchbacks may occur.

Riding skills: Advanced riding skills are needed. Use weight shifts to negotiate obstacles. This requires control of your centre of gravity, body tension, finely controlled braking and constant readiness to brake.

Gradient: In places up to 70% (about 35°) · S2 in the original source ↗

S3

Difficult

Rocky, steep and demanding

Numerous large rocks or roots, high steps, tight switchbacks and difficult off-camber traverses leave few relaxed rolling sections. Loose scree and slippery patches are common.

Riding skills: Very confident bike control, continuous concentration, precise braking and strong balance are required. Special trials techniques are not yet a requirement for S3.

Gradient: Often over 70% (more than about 35°) · S3 in the original source ↗

S4

Difficult

Extremely steep sections requiring trials skills

Large boulders and difficult roots lie in very steep, heavily obstructed terrain, often with loose scree. Extreme ramps, very tight hairpin turns and ledges high enough for the chainring to strike are typical.

Riding skills: Perfect balance and braking, along with trials techniques such as deliberate repositioning of the front and rear wheels, are essential. This grade is for exceptionally skilled extreme riders. Even carrying the bike downhill is often dangerous.

Gradient: Over 70% (more than about 35°) · S4 in the original source ↗

S5

Difficult

Extreme combinations of obstacles

Extremely steep boulder terrain with counter-climbs, scree or landslides combines with hairpin switchbacks, several high steps in immediate succession and obstacles such as fallen trees. Run-out and braking distance are largely absent. Individual obstacles must be negotiated as part of the whole sequence.

Riding skills: Only very few specialists attempt these sections. Excellent specialist trials skills are required, and some obstacles have to be jumped. There is hardly any room to reposition both wheels. Even carrying the bike is almost impossible where walking requires holding on or climbing.

Gradient: Well over 70% (considerably more than 35°) · S5 in the original source ↗

One trail, different demands

A trail can contain different difficulty grades, such as S2 with individual S3 sections. Not all features of a grade need to occur together for that grade to apply.

What do plus and minus mean?

Minus and plus indicate the lower and upper parts of a grade respectively. S2+, for example, is harder than an average S2. There is no fixed boundary between S2+ and S3−; these finer distinctions require experience.

Based on the Singletrail Scale by Carsten Schymik, David Werner and Harald Philipp. The features are described here in our own words. Detailed explanations and example photographs are available at singletrail-skala.de.

Which tour suits your ability?

Tell us which trails you feel confident on. This helps us match our tour requirements to your experience.

Our partners